Building a Base Assembly with a Shaped Front Toe in Solid

For this example you will want to start out with a Std Base and take it to the Assembly Editor, in the Section View.


1. Select the Bottom Rail and change the width to the necessary size.




2. Next, go to the Face Orthographic View, right click on the Bottom Rail, select Edit Shape and shape the rail as necessary.

 


3. Now, you will want to go back to the Section View.  Go to the Properties Tab and select Toe.  Or, you can also just right click on the screen, select Assembly, and then the Toe tab.  Either of these options will take you to the following screen:

 

4. If you want the underneath of the assembly to be open all the way back to the wall it is attached to, type in 0 in the Toe Height box and hit OK. The result should look like the following:

 
 

Or, if you want a sub toe to set in behind the arched rail, type in 0.001 (if you are using metric - 0.1 will suffice) in the Toe Height box and hit OK. The result should look like the following:

 

 


 

Close Icon